Fire Exit Door Handle Requirements
Fire doors must also be fitted with an as1905 1 fire rated automatic door closer.
Fire exit door handle requirements. The final fire exit door must. And one that can be easily used at all light levels. The door should open in the direction of evacuation. In the case of fire doors the lock must be self latching and be fire rated in accordance with as1905 1.
For instance a latch or some other fastening device is a requirement for doors with a simple releasing device. 1910 36 a 1 an exit route must be permanent. Hardware consisting of bars that extend to at least half of the width of the door leaf. Above all equip doors with panic hardware and fire exit hardware.
There are also additional requirements where the door is the final exit point of a building. Many use a push bar system that will open the door when pressed down. Each exit route must be a permanent part of the workplace. Only fire rated hardware may be fitted to fire rated doors.
Locks must be fitted at a height of between 900mm and 1100mm from the floor level. 1910 36 a 2 an exit must be separated by fire resistant materials. Any additional door hardware must also be appropriately fire rated. Exit routes must meet the following design and construction requirements.
Sps 375 24 3 3 a standard exit door shall have such fastenings or hardware that it can be opened from the inside without using a key by pushing against a single bar or plate or turning a single knob or handle. There should be no locks or catches.